Resumo:
Microgrids are a very good solution for current problems raised by the constant growth
of load demand and high penetration of renewable energy sources, that results in grid
modernization through “Smart-Grids” concept. The impact of distributed energy sources
based on power electronics is an important concern for power systems, where natural
frequency regulation for the system is hindered because of inertia reduction. In this context,
Direct Current (DC) grids are considered a relevant solution, since the DC nature of power
electronic devices bring technological and economical advantages compared to Alternative
Current (AC). The thesis proposes the design and control of a hybrid AC/DC Microgrid
to integrate different renewable sources, including solar power and braking energy recovery
from trains, to energy storage systems as batteries and supercapacitors and to loads like
electric vehicles or another grids (either AC or DC), for reliable operation and stability.
The stabilization of the Microgrid buses’ voltages and the provision of ancillary services
is assured by the proposed control strategy, where a rigorous stability study is made.
A low-level distributed nonlinear controller, based on “System-of-Systems” approach is
developed for proper operation of the whole Microgrid. A supercapacitor is applied to
deal with transients, balancing the DC bus of the Microgrid and absorbing the energy
injected by intermittent and possibly strong energy sources as energy recovery from the
braking of trains and subways, while the battery realizes the power flow in long term.
Dynamical feedback control based on singular perturbation analysis is developed for
supercapacitor and train. A Lyapunov function is built considering the interconnected
devices of the Microgrid to ensure the stability of the whole system. Simulations highlight
the performance of the proposed control with parametric robustness tests and a comparison
with traditional linear controller. The Virtual Synchronous Machine (VSM) approach is
implemented in the Microgrid for power sharing and frequency stability improvement. An
adaptive virtual inertia is proposed, then the inertia constant becomes a system’s state
variable that can be designed to improve frequency stability and inertial support, where
stability analysis is carried out. Therefore, the VSM is the link between DC and AC side
of the Microgrid, regarding the available power in DC grid, applied for ancillary services
in the AC Microgrid. Simulation results show the effectiveness of the proposed adaptive
inertia, where a comparison with droop and standard control techniques is conducted.